12V Reciprocating Compressor
Duty Cycle: 100% @ 200psi
Flow: 2.24 CFM (cubik per minute)
Maximum 200 PSI = 13.8 Bar
Fuse: 40A (not included)
L/W/H = approx. 27.5cm / 10.5cm / 17cm
3/8" stainless steel main lines with check valves

To ensure trouble-free operation of the compressor, the following points must be checked:
The compressor must only be operated with a 40 A fuse! Over or under amperage of the fuse is not allowed. If you install several compressors, each compressor needs its own fuse.
The compressor can only be installed and operated in areas protected against water and heat.
The compressor is a dry rotor and does not therefore requires no lubricating oil. The compressor may only be operated with a fully functional and fully charged vehicle battery, otherwise the compressor coil may be damaged by the high starting current (if the voltage is too low).
Ensure secure and sufficient conductivity of the ground cable between the compressor and the body.
Always ensure a sufficient supply of fresh air.