Klutch wheels
Klutch Wheels
Rasl'Bitume distributes the Klutch range, with actual stock displayed piece by piece. All our Klutch wheels are sold individually.
Klutch is an American brand of lightweight wheels for compact cars, featuring designs inspired by Japanese racing wheels from the 1990s. A catalog deliberately focused — two models in 15 and 16 inches — but with dimensions wide range of sizes rarely offered in these small diameters.
Almost all references are TÜV approved, with a certificate downloadable directly from the product page.
Unsure about the bolt pattern, offset, or clearance under the fender? Contact us before you order, we'll confirm the fitment with you.
What comes with your wheels
The centering rings and center cap are included. The wheel bolts, however, remain optional for this brand: tell us your vehicle and we'll let you know whether yours fits.
The TÜV certificate
Available for download from the product page for approved references. Useful for your insurer or an inspection.
Centering rings
Sized to match your hubs, they are supplied free of charge. They fill the gap between the hub and the wheel's center bore.
The center cap
Matching and supplied with the wheels.
Wheel bolts — optional
It is not included with Klutch. Depending on your vehicle, the original one may fit; otherwise, see our lug nut packs and wheel bolts.
Rare widths in small diameters
Klutch focuses on 15- and 16-inch wheels, in widths ranging from 8 to 8.5 inches that few manufacturers offer in these diameters. This is a sought-after fitment on compact older cars and Japanese youngtimers, where a large diameter makes the car look heavier and unnecessarily widening the wheel without adding anything.
However, beware of the offset: with these widths, it is deliberately low (ET 10 to 17), which makes the wheel stick out. Check the clearance under the fender and the front suspension travel before ordering—we can do it with you.
Frequently asked questions
Where can I find the TÜV certificate?
On the product page for approved references: the download link appears in the “TÜV Approval” section. The certificate lists the vehicles covered and any potential fitting requirements.
What does “4 holes – custom” mean on certain references?
The bolt pattern of these wheels is machined to order within the range indicated on the specification sheet (for example, 4 holes from 98 to 114.3 mm). Indicate your vehicle when ordering so that we can machine the correct specifications; allow approximately one week for delivery additional.
How do I choose between two sizes?
The bolt pattern must match the hole pattern of your hubs exactly. The offset (ET) determines the wheel’s position in the wheel arch: the lower it is, the more wheel and spring. The center bore must be greater than or equal to the hub. If in doubt, send us your registration certificate.
Can I order a single wheel?
Yes, all our Klutch wheels are sold individually. Adjust the quantity in the cart: 2 for one axle, 4 for the full set. This is also what allows you to fit different widths at the front and rear.
