









Exhaust manifold with heat shield for Audi R8 V10, Lamborghini Gallardo, Huracan — TA Technix
Ref. EVOFÄR8H
- Secure payment
- 14-day returns
- Technical support
Exhaust manifold with thermal protection for Audi R8 V10, Lamborghini Gallardo, Huracan
Features
What this part changes
On a naturally aspirated engine, the manifold is the exhaust component that changes its character the most, and the only one that works through pressure waves, not just flow. Equal-length tubes allow each cylinder to empty without interfering with the next one: volumetric efficiency improves, along with torque over a given rev range.
The design determines the power band: a 4-2-1 brings torque back into the mid-range, which is well suited to road use; a 4-1 shifts everything higher up and weakens the low end, making sense only with a camshaft and exhaust system to match. A performance manifold installed alone on a stock engine delivers a real but modest gain - it is a component that must be considered as part of a complete setup.
What to plan for
- New gaskets and studs in good condition: one stud out of two breaks during removal, so plan for the gasket kit and an extractor.
- Check the lambda sensor location: the length changes, and the port must be present.
- Check clearance around the steering column and starter motor on 4-1 designs.
Compatible vehicles
| Make | Model | Engine | Years |
|---|---|---|---|
| Audi | R8 including Spyder | 5.2l V10 | — |
Frequently bought together
Enthusiasts at your service
since 2017
A question about your order or your car? contact@raslbitume.com

